In today's article I will tell and clearly show you how to properly remove a blockage in a sink using vinegar and baking soda. I'm sure that 99% of my channel readers know about this old way of dealing with blockages, but I'm also sure that only a few know how to use it correctly and as effectively as possible. About a week ago, my mother-in-law had a blockage in the kitchen sink. The pipe cleaner did not cope with the problem and I decided to pour in some baking soda and pour vinegar over it, but again there was no result. Then I had to deal with this issue and find a solution, my husband suggested it to me. I wrote detailed instructions for you.
To use this method correctly, you first need to wait until the water leaves the sink and pour it into the drain hole. half a packet of baking soda. Then take 9% vinegar solution (100 milliliters) pour into any container and heat in the microwave, 15-20 seconds of heating on high mode will be quite enough. Warmed vinegar
pour into the drain hole. Scroll the photo to the right.After the resulting reaction We plug the drain hole with a rag and wait about 30-40 minutes. After this time, remove the rag and pour it into the sink kettle of boiling water. Then turn on cold water for 2-3 minutes. This method coped with our, not weak, blockage. I am sure that this method can be used to unclog almost any blockage. If the article was interesting - put your finger up and, if not signed yet, subscribe to the channel! Scroll the photo to the right.